UKCSA Quality Mark

Quality Marking cast stone

Quality Mark for cast stone

Quality Mark for cast stone

Quality Mark for cast stone

Cast Stone acceptability

Technical

UKCSA Quality Mark for Cast Stone

Cast stone products manufactured by an UKCSA Full Member to the Association’s stringent requirements and specification are already supplied to a standard in excess of the BS 1217 requirements.

However, the UK Cast Stone Association agreed at its January 2013 Executive Committee Meeting to introduce its own Quality Mark standard for cast stone, which all UKCSA manufacturing members will be required to comply with as a condition of their membership.

The Association's work on the Quality Mark Scheme is now complete and from 1st May 2013 if users and specifiers of cast stone require further reassurance that the cast stone they are using is durable and produced to the highest standards, then they should look for the Quality Mark label on the cast stone.

The UKCSA Quality Mark label will only be available on cast stone which has been purchased from an UKCSA Member. The inclusion of a Quality Mark label on cast stone is the UKCSA manufacturing member's confirmation that the cast stone supplied complies with all of the Quality Mark Scheme requirements.

Aspects of cast stone which are covered by the UKCSA Quality Mark Scheme include:

Cast Stone Manufacturer's Details

The name and contact details of the UKCSA manufacturing member who is certifying that the cast stone conforms to all requirements of the UKCSA Quality Mark Scheme shall be stated on the Quality Mark Label.

Material Type

The manufacturer shall state the cast stone material type, which shall be either dry-cast cast stone, wet-cast cast stone or fibre reinforced cast stone .

Cube Compressive Strength

The cast stone shall have a minimum cube compressive strength of 35 MPa, which represents a strength at least 40% higher than the BS 1217 requirement.

Dimensional Tolerance

The dimensional tolerance of the cast stone shall be in accordance with the UKCSA Specification / BS 1217, Clause 8.1.

Flatness of Plane

The flatness of plane of the cast stone shall be in accordance with the UKCSA Specification / BS 1217, Clause 8.2.

Weathering Grade

The permeability and durability of the cast stone, when tested in accordance with the Capilliary Absorption Test (CAT) shall not exceed 1.0mg/mm2.
Download UKCSA Guidance Note: Capillary Absorption Test (CAT)

Durability Against Freeze / Thaw

Products complying with these requirements are deemed to be freeze / thaw resistant.

Bond Strength

In accordance with BS EN 998-2 for general purpose mortar - the Characteristic Shear Strength is 0.15N/mm2.

Thermal Conductivity

In accordance with BS EN 1745 – λ value for cast stone is in region of 1.2 to 1.7 W/mK for a 5% moisture content product.

Reaction to Fire

Cast stone products shall be in accordance with Euroclass A1 requirements.

Acceptability of Surface Finish

Acceptability of surface finish shall be in accordance with the UKCSA Acceptability Guidance Note.

 

Do not accept second best when it comes to cast stone -
insist on the UKCSA Quality Mark!

Get quality cast stone quote

< Back

 
Share |    

 

Follow cast stone on   Follow Cast Stone on Blogger     Follow Cast Stone on Twitter     Follow Cast Stone on Facebook